[ROVERNET - UK] P6 engine mounts

[Paul Smith]

I'm talking about the rubber mounts on a 4, SC.  I can't see any cutdown.

-----Original Message-----
From: Pjemail at aol.com [mailto:Pjemail at aol.com]
Sent: Thursday, 8 July 2004 4:05 am
To: rovernet at lyris.ccdata.com
Subject: Re: [ROVERNET - UK] P6 engine mounts


It all depends on what model you are talking about. If you do mean a P6 (i.e
a 4 cylinder model) then on TC models the mountings do differ left from
right. The LH one has a bas which is cut down in order to provide clearance
for the manifold etc. You can therefore use a LH one on the Right, but to do
it vice versa you will need to cut the base plate.

On V8 models the mounts are the same on each side.

Regards,

Pierre Janusz

_______________________________________________
rovernet mailing list
rovernet at lyris.ccdata.com
To unsubscribe, go to this web page, look near the bottom and follow
instructions:
http://mailman.nipltd.com/mailman/listinfo/rovernet