[ROVERNET - UK] Brake Rotor Thicknesses

[Fritz Rauschenberg]

Eric,
Can't be .0500 - that is less than 1/16" You surely meant .500 which is 1/2" ??

Fritz
Atlanta

Eric Russell wrote:

> Glen,
> I measured my 2000 TC new rotors at 0.0500 inches
> I believe (source lost in the mists of time) that the
> 3500 S disks were slightly thicker.  Pierre, where are
> you (keeper of new rotors :-)
>
> Eric
>
> --- Glen Wilson <glenwilson at ixpres.com> wrote:
> > Thanks, John.  Is there a page in the manual I can
> > refer them to?  Where
> > did you get your info from?
> >
> > Glen
> >
> > JOHN HALL wrote:
> >
> > > 0.385" min. thickness.
> > >
> > > _______________________________________________
> > > rovernet mailing list
> > > rovernet at lyris.ccdata.com
> > > To unsubscribe, go to this web page, look near the
> > bottom and follow instructions:
> > >
> > http://mailman.nipltd.com/mailman/listinfo/rovernet
> > >
> > >
> >
> > --
> > Glen Wilson
> > Suburban Philadelphia
> > USA
> >
> > _______________________________________________
> > rovernet mailing list
> > rovernet at lyris.ccdata.com
> > To unsubscribe, go to this web page, look near the
> > bottom and follow instructions:
> > http://mailman.nipltd.com/mailman/listinfo/rovernet
>
>
>
> __________________________________
> Do you Yahoo!?
> Friends.  Fun.  Try the all-new Yahoo! Messenger.
> http://messenger.yahoo.com/
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet