[ROVERNET - UK] PcB - Query please re: vaccum tube
fromdistributor
Peter Mitchell
peterm at arach.net.au
Sun Nov 21 02:15:47 GMT 2004
Many thanks Roy, that does ring a bell.
Kind regards
Peter
-----Original Message-----
From: rovernet-bounces at lyris.ccdata.com
[mailto:rovernet-bounces at lyris.ccdata.com]On Behalf Of Ray Wilkins
Sent: Sunday, 21 November 2004 9:37 AM
To: rovernet at lyris.ccdata.com
Subject: RE: [ROVERNET - UK] PcB - Query please re: vaccum tube
fromdistributor
Hi Peter,
It should have an 'L' shaped rubber connector on the other end and it
fits underneath the right hand carburetor housing. Hope this helps.
Regards,
Ray Wilkins
1976 P6B
Melbourne Australia
-----Original Message-----
From: rovernet-bounces at lyris.ccdata.com
[mailto:rovernet-bounces at lyris.ccdata.com] On Behalf Of Peter Mitchell
Sent: Saturday, 20 November 2004 11:32 PM
To: Rovernet
Subject: [ROVERNET - UK] PcB - Query please re: vaccum tube from
distributor
Hello Rovernetters
I've recently replaced the inlet manifold off my 76 P6B as the original
had
become thin due to corrosion.
I don't have a manual, and almost have everything back together,
expecting
for being rather vague as to where to fit the other end of the thin tube
that connects to the distributor.
Would a kind, fellow P6B owner mind very much enlightening me as to
where I
might connect this tube, which is presumably to do with the vacuum
advance?
Kind regards
Peter Mitchell
Perth Western Australia
_______________________________________________
rovernet mailing list
rovernet at lyris.ccdata.com
To unsubscribe, go to this web page, look near the bottom and follow
instructions:
http://mailman.nipltd.com/mailman/listinfo/rovernet
_______________________________________________
rovernet mailing list
rovernet at lyris.ccdata.com
To unsubscribe, go to this web page, look near the bottom and follow
instructions:
http://mailman.nipltd.com/mailman/listinfo/rovernet
More information about the rovernet
mailing list