[ROVERNET - UK] P6B front windscreen removal tips sought
Eric Russell
p6rovers at yahoo.com
Mon Dec 19 16:13:11 GMT 2005
Peter,
I have removed many windshields and installed about 3.
My installation success is about 66%. The keys:
*location of the windscreen and rubber assembly in the
channel of the base unit
*the tightening of the 2 "lifting clamps" must be
gentle and equal
*don't tighten the "lifting clamps" too much or you
will develop tension in the glass
I came down to the garage one morning after installing
a glass to find that it had cracked badly.
On the other hand, I installed two others which were
not a problem.
Eric
--- Peter Mitchell <peterm at arach.net.au> wrote:
> Hello Netters,
>
> or should that be 'Ho Ho Ho netters'!
>
> The ball joints purchased from Scott have now been
> fitted by a Rover
> mechanic friend, and I am now keen to tackle the
> fitting of a new front
> windscreen to my P6B.
>
> In the opinion of those who have done this job
> before, is the replacement of
> a windscreen a job for a beginner, or should it be
> left to a specialist?
>
> Kind regards
>
> Peter Mitchell
> Perth Western Australia
>
>
>
>
>
>
>
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the
> bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> Back-up list and photos at:
> http://autos.groups.yahoo.com/group/Rover_net/
>
Webmaster & Magazine Editor:
The Rover Car Club of Canada - www.roverclub.ca
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
More information about the rovernet
mailing list