Paul Smith Paul.Smith at auroraenergy.com.au
Fri Jul 8 00:51:28 BST 2005

1.  100 and 110 had 4.3 as standard with OD.  Think 80 did too.
95 had 3.9 as standard, no OD.
2.  Only way I know is to drop axles out a few inches, disconnect tailshaft,
remove diff.  Probably easier to change rear axle complete.


-----Original Message-----
From: Ben Rodgers [mailto:irishrover at netscape.ca]
Sent: Friday, 8 July 2005 9:36 am
To: rovernet at lyris.ccdata.com
Subject: Re: [ROVERNET - UK] P5 Gas MPG

Hi Barry
            Thats very interesting, and according to the factory manual you
are indeed correct, 4sp with o/d has 4.3.1 rear end. I just happen to have a
Mk1A auto behind the barn so if I can muster the energy I'll have to give it
a try.
I was under the impression that all the later P4's were 3.9.1 rear ends?
What about those 100's with o/d did they have the 4'3'1 diff also???? While
on the subject Barry,  is there a quick and easy way to change the diff's?
or is there only one method, the hard way?
Thanks for the info.

rovernet mailing list
rovernet at lyris.ccdata.com
To unsubscribe, go to this web page, look near the bottom and follow

More information about the rovernet mailing list