[ROVERNET - UK] Clickety Clat
Fritz Rauschenberg
wfritz at mindspring.com
Sun Mar 27 11:42:35 BST 2005
Did you put oil in the engine after the valve job/head overhaul? That could make a lot
of noise. Seriously, it would be a good idea to re-fit shims to get the clearances
spot on.
Fritz Rauschenberg
Atlanta
Nottingham Road Giftware wrote:
> Hello All.
>
> I just replaced the head on my TC -- Ground valves/new seats etc. and there
> is too much valve clatter. The tappet clearances are very close to spec,
> with most right-on (within .002 off-spec worst case). Valve springs are
> good. Oil ways are clear to all cam bearings etc. The car runs great, but
> the noise is getting on my nerves. I have had valve clearances way off in
> the past and they did not make much noise. It does not seem like one valve,
> but it is equal amongst all of them. Anybody have the same problem? Should
> I ignore it and keep on motoring?
>
> Steve Lawrence
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
More information about the rovernet
mailing list