[ROVERNET - UK] Many thanks ---engine rebuild

[Eric Russell]

Also, make sure your tongue is held at the correct
angle ;-)

Eric


--- Paul Smith <vmitps at netspace.net.au> wrote:

> Just remember you have Rover's usual generous
> clearances when doing the 
> engine lift ie. about 3mm...
> 
> PVS
> 
> ----- Original Message ----- 
> From: "Lance La Certe" <lacpsyd at earthlink.net>
> To: "Rovernet" <rovernet at lyris.ccdata.com>
> Sent: Thursday, October 06, 2005 2:55 PM
> Subject: [ROVERNET - UK] Many thanks ---engine
> rebuild
> 
> 
> > As usual,  all of the help I get from the Rovernet
> is truly priceless.
> > Just wanted to thank everyone who provided input
> about pulling and
> > reinstalling the V8 engine.  I think I've got
> enough confidence to go
> > forward.
> >
> >
> > Lance La Certe,  '70  Federal 3500S
> > lacpsyd at earthlink.net
> >
> >
> >
> >
> >
> > _______________________________________________
> > rovernet mailing list
> > rovernet at lyris.ccdata.com
> > To unsubscribe, go to this web page, look near the
> bottom and follow 
> > instructions:
> >
> http://mailman.nipltd.com/mailman/listinfo/rovernet 
> 
> 
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the
> bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> 


Webmaster & Magazine Editor:
The Rover Car Club of Canada -  www.roverclub.ca


		
__________________________________ 
Yahoo! Mail - PC Magazine Editors' Choice 2005 
http://mail.yahoo.com