[ROVERNET - UK] 3500s brake light switch

[peter king]

Thanks to all=97I do have a dual system, so the switch was mounted =20
under the dash, plunger activated from the pedal. Just needed to be =20
tightened a turn or so, probably due to wear on the plunger.

Peter



On Sep 17, 2005, at 11:16 PM, geffandjulie wrote:

> On my NADA 3500S it is inside the cockpit on the brake pedal.
> ----- Original Message ----- From: "Peter King" <peter at king-co.com>
> To: <rovernet at lyris.ccdata.com>
> Sent: Friday, September 16, 2005 9:44 AM
> Subject: [ROVERNET - UK] 3500s brake light switch
>
>
>
>> Hi all.
>>
>> Brake lights are out on the 3500S. I took a quick look this =20
>> morning but found only the brake failure switch on the side of the =20=

>> servo. Manual locates it on the bottom of the servo, but it's not =20
>> there. I'll be digging deeper this weekend, but can anyone tell me =20=

>> if the switch is fluid-operated or a contact switch, and where it =20
>> is located?
>>
>> Thanks much,
>>
>> Peter
>>
>>
>>
>>
>> Peter King
>> Principal
>> Peter King & Company
>> 368 Congress Street
>> Boston, MA 02210
>> 617.292.7877
>> www.king-co.com
>>
>>
>> _______________________________________________
>> rovernet mailing list
>> rovernet at lyris.ccdata.com
>> To unsubscribe, go to this web page, look near the bottom and =20
>> follow instructions:
>> http://mailman.nipltd.com/mailman/listinfo/rovernet
>>
>
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and =20
> follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
>