[ROVERNET - UK] SD1 rim and brake servo part needed
kkinard at swbell.net
Sat Feb 4 22:05:28 GMT 2006
I have an extra SD1 rim (probably several sets). You will need to
change the studs in the P6 hubs to metric or get SAE nuts to fit the SD1
wheels (easier). Then check for runout after the wheels are mounted.
Some SAE replacement lugnuts are not a tight fit in the SD1 wheels.
There's probably something about this in the archives if you care to
dig. Where are you?
How much for the Magstars?
> I have 4 SD1 rims here in Oregon, and 4 Magstars, all in good condition.
> Would sell either set, but would not sell just one.
> ----- Original Message ----- From: "George Phelps" <mrpink703 at yahoo.com>
> To: <rovernet at lyris.ccdata.com>
> Sent: Wednesday, February 01, 2006 5:46 AM
> Subject: [ROVERNET - UK] SD1 rim and brake servo part needed
>> Hello all. Depite the many (too many) parts I have, I
>> still need more. As is always the case with these
>> Anyway, I need one SD1 rim to go with my other three
>> and the requisite lug nuts. Also, in removing my
>> brake servo, I sheared off one of the securing bolts.
>> So, although the rest of it looks rebuildable, I now
>> could use a case for the vacum resevoir (I only need
>> the larger half). Anybody have one of these sitting
>> uselessly on a work bench somewhere? I probably could
>> trade something for these bits. Let me know if you
>> need anything. The car I am working on is a 1970 NADA
>> p6_rover (at) yahoo (dot) com
>> Do You Yahoo!?
>> Tired of spam? Yahoo! Mail has the best spam protection around
>> rovernet mailing list
>> rovernet at lyris.ccdata.com
>> To unsubscribe, go to this web page, look near the bottom and follow
>> Back-up list and photos at:
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow
> Back-up list and photos at:
More information about the rovernet