[ROVERNET - UK] P6B- New springs but still leaning slightly...
vmitps at netspace.net.au
Fri Jan 27 20:23:28 GMT 2006
Yes; was a free length check carried out on the springs prior to install?
They should be the same, not 6mm different (which would produce 12 on the
----- Original Message -----
From: "Vern Klukas" <vern at inkspotco.com>
To: <rovernet at lyris.ccdata.com>
Sent: Saturday, January 28, 2006 4:19 AM
Subject: Re: [ROVERNET - UK] P6B- New springs but still leaning slightly...
> There are "shims" that sit on top of the spring, between the rubber
> cushion and the spring. Adding some of those should fix it up. The
> other possibilty is that the rubber cushion is missing (thought I
> think that would be more than a half inch change) or degraded.
> >Hello Netters
> >I've had new rear springs fitted to my P6B, and she is sitting up much
> >better and looks great.
> >There still however appears to be a drop on the right hand side, when
> >from the rear, of 10mm / 0.5".
> >I do recall from somewhere that there is an adjustment that can be made
> >correct such problems.
> >Advice would be gratefully received.
> >Kind regards
> >Peter Mitchell
> >Perth Western Australia
> >rovernet mailing list
> >rovernet at lyris.ccdata.com
> >To unsubscribe, go to this web page, look near the bottom and follow
> >Back-up list and photos at:
> Vern Klukas I'm a little . . .
> Inkspot Type & Design
> vern at inkspotco.com
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow
> Back-up list and photos at:
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.375 / Virus Database: 267.14.23/242 - Release Date:
More information about the rovernet