[ROVERNET - UK] uns*bscribe
David Read
defender110 at ozemail.com.au
Mon May 15 06:22:29 BST 2006
Andrew !!!!!
You forgot to mention that re-subcribing is the reverse of the above.
:-)
Dave
South Oz
Andrew H. Litkowiak wrote:
> Peter Mitchell wrote:
>> Hi Eric,
>>
>> I am going off the net for a week or two for pc repair / upgrade, please
>> unsubscribe me for the present.
>>
>> Kind regards
>
> Here is how to unsubscribe:
>
> First, e-mail rovernet-request and ask for an Unsubscribing Kit. Then
> follow these simple directions.
>
> The kit is the standard no-fault type. Depending on requirements, System
> A and/or System B can be used. When operating System A, depress lever
> and a plastic dalkron unsubscriber will be dispensed through the slot
> immediately underneath. When you have fastened the adhesive lip, attach
> connection marked by the large "X" outlet hose. Twist the silver-
> colored ring one inch below the connection point until you feel it lock.
>
> The kit is now ready for use. The unsubscriber is activated by the small
> switch on the lip. When securing, twist the ring back to its initial
> condition, so that the two orange lines meet. Disconnect. Place the
> dalkron unsubscriber in the vacuum receptacle to the rear. Activate by
> pressing the blue button.
>
> The controls for System B are located on the opposite side. The red
> release switch places the unsubscriber into position; it can be adjusted
> manually up or down by pressing the blue manual release button. The
> opening is self-adjusting. To secure after use, press the green button,
> which simultaneously activates the evaporator and returns the
> unsubscriber to its storage position.
>
> You may log off if the green exit light is on over the evaporator. If
> the red light is illuminated, one of the unsubscriber requirements has
> not been properly implemented. Press the "List Admin" call button on the
> right of the evaporator. I will secure all facilities from my control
> panel.
>
> To use the Auto-Unsub, first undress and place all your clothes in the
> clothes rack. Put on the Velcro slippers located in the cabinet
> immediately below. Enter the Con-tainer, taking the entire kit with you.
> On the control panel to your upper right upon entering you will see a
> "Con-tainer seal" button. Press to activate. A green light will then be
> illuminated immediately below. On the intensity knob, select the desired
> setting. Now depress the Auto-Unsub activation lever. Act normally.
>
> The Auto-Unsub will automatically go off after three minutes unless you
> activate the "Manual off" override switch by flipping it up. When you
> are ready to leave, press the blue "Con-tainer seal" release button. The
> door will open and you may leave. Please remove the Velcro slippers and
> place them in their receptacle.
>
> If you prefer the ultrasonic log-off mode, press the indicated blue
> button. When the twin panels open, pull forward by rings A & B. The knob
> to the left, just below the blue light, has three settings, low, medium
> or high. For normal use, the medium setting is suggested. After these
> settings have been made, you can activate the device by switching to the
> "ON" position the clearly marked red switch. If during the Unsubscribing
> operation, you wish to change the settings, place the "manual off"
> override switch in the "OFF" position. You may now make the change and
> repeat the cycle. When the green exit light goes on, you may log off and
> have lunch. Please close the door behind you. Don't forget to dressb
> efore leaving the room.
<snip>
More information about the rovernet
mailing list