[ROVERNET - UK] P6 Rear Axle

Paul Smith Paul.Smith at auroraenergy.com.au
Mon May 29 23:59:36 BST 2006


Yes well asked Vern.
I have not had Any problem with a P6 diff.  For 2 to fail does not sound
right to me.
I now have an oil weep from the LH stub, so I need to rebuild the spare in
preparation.

PVS

-----Original Message-----
From: rovernet-bounces at lyris.ccdata.com
[mailto:rovernet-bounces at lyris.ccdata.com]On Behalf Of Vern Klukas
Sent: Tuesday, 30 May 2006 7:40 am
To: rovernet at lyris.ccdata.com
Subject: Re: [ROVERNET - UK] P6 Rear Axle


If the hubs had too much preload, I would expect them to overheat and 
fail long before the diff.

Could you provide more details.4cyl or V8? Exactly what was the 
failure? Did the gears strip? I presume you are talking about the 
small gears inside the diff carrier, not the crown and pinion gear. 
Did the stub axles fail?

Yours
Vern




>There is a P6 out here that is having problems with the 
>differential.  The owner, not having a computer asked me to ask all 
>of you for some help.  The car had been in storage for some time. 
>He got the car running and everything at the rear seemed normal for 
>about 600 or so miles.  Then the rear hubs were determined to need 
>rebuilding.  This was done with new bearings, seals and crush 
>spacers.  Just after this service was performed the differential 
>problem started.  After just a few days of driving the differential 
>side and pinion gears failed.  The complete rear axle assembly was 
>replaced with a used unit and the same thing happened again.  My 
>first thought is that the rear hubs pre-load was incorrectly set. 
>An other ideas?  Thank you for the help.  jb
>
>
>_______________________________________________
>rovernet mailing list
>rovernet at lyris.ccdata.com
>To unsubscribe, go to this web page, look near the bottom and follow 
>instructions:
>http://mailman.nipltd.com/mailman/listinfo/rovernet
>Back-up list and photos at:
>http://autos.groups.yahoo.com/group/Rover_net/


-- 
Vern Klukas                             I'm a little . . .
Inkspot Type & Design
vern at inkspotco.com

_______________________________________________
rovernet mailing list
rovernet at lyris.ccdata.com
To unsubscribe, go to this web page, look near the bottom and follow
instructions:
http://mailman.nipltd.com/mailman/listinfo/rovernet
Back-up list and photos at:
http://autos.groups.yahoo.com/group/Rover_net/




More information about the rovernet mailing list