[ROVERNET - UK] Clutch master cylinder

[Fritz Rauschenberg]

Great idea Creig, Thanks !

Fritz Rauschenberg
Atlanta


> [Original Message]
> From: Creig Houghtaling <oldtoys at charter.net>
> To: <rovernet at lyris.ccdata.com>
> Date: 9/18/2006 9:44:42 PM
> Subject: RE: [ROVERNET - UK] Clutch master cylinder
>
> Steven,
> The method an old mechanic taught me to bleed a clutch system is very
> similar to Eric Russell's method.  That is to disconnect the slave, let it
> hang down so the bleed screw is at the highest point.  Attach a long clear
> rubber tube to the bleed screw and put the open end back to the master
> reservoir.  Then pump till there is no more air coming up the tube.
> With this method you can pump as much as needed to remove all the air from
> both the master and slave and with the clear tube coming back up to the
> reservoir you can easily see when the air is gone.
> Creig Houghtaling
> St. Louis, MO
>
> -----Original Message-----
> From: rovernet-bounces at lyris.ccdata.com
> [mailto:rovernet-bounces at lyris.ccdata.com]On Behalf Of Steven Dibdin
> Sent: Monday, September 18, 2006 7:34 AM
> To: rovernet at lyris.ccdata.com
> Subject: [ROVERNET - UK] Clutch master cylinder
>
> --
> No virus found in this outgoing message.
> Checked by AVG Free Edition.
> Version: 7.1.405 / Virus Database: 268.12.5/450 - Release Date: 9/18/2006
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow
instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> Back-up list and photos at:
> http://autos.groups.yahoo.com/group/Rover_net/