[ROVERNET - UK] SD1 (Vitesse) - Manual Gearbox Vibrations
onSwitching & Replacement of Engine f+r Oil Seals?
Kent Kinard
kkinard at wcc.net
Thu Sep 28 11:49:17 BST 2006
There may be a groove worn into the sealing surface of the
crank damper in which case a new front seal by itself will
not stop the leak. Check the wear surface for a groove.
If one is present, you must fit a repair sleeve to the
damper before installing the new seal. If you can't get a
sleeve for a Rover, use one for a '62-'87 Buick V-6. It
must be positioned at the point of wear and should be
locked in place with Locktite Stud and Bearing Mount or
similar. If not locked in place, it will "walk" away from
the contact spot since it is not really long enough to
cover the whole surface.
Roverleakedly,
Kent K.
On Thu, 28 Sep 2006 15:21:15 +1000
<Gavin.Walker at csiro.au> wrote:
>Front engine seal is easy.
>
> - Remove the pulley cluster
> - Pull the seal out
> - put a new seal in
>
> Never done a rear or had a SD1 manual gearbox.
>
> Gavin Walker
> Canberra, Australia
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the
>bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> Back-up list and photos at:
> http://autos.groups.yahoo.com/group/Rover_net/
More information about the rovernet
mailing list