[ROVERNET - UK] P6 - sill fasteners
p6rovers at yahoo.com
Tue Jul 31 16:34:16 BST 2007
Under the floor to fasten the sills:
Nylon clinch nut, round head, square shank
Part number, 367838
I can look at the local parts store and see if they
have them. I noticed a rotating rack with such things
and bought there square head items at one point.
I can check them out, and send them over - unless you
can wait until October 3 when I can BRING them over
Personally, I didn't recut those square holes in the
metal when I restored my cars. I used a stainless
steel self-taping screw with SS washer and screwed the
sill onto the florr directly.
--- Peter Mitchell <peter_m at amnet.net.au> wrote:
> Hi fellow Rovernetters,
> My P6B has at long last had its engine rebuild
> completed (re-linered to 3.9
> litre) and the car is now back on the road as my
> daily driver. The engine
> is still running in but already I am aware of the
> considerable boost in
> power that I have gained over my exhausted old 3.5.
> I need to smarten up the fixing of the sill covers
> where they attach under
> the vehicle. The stout screws that run down along
> the body below the doors,
> hold the sill covers on soundly, but underneath the
> car there appear to be a
> series of plastic plugs that each receive a screw,
> and some are missing.
> Right close to where I work there is a Coventrys
> Fasteners store, but I'd be
> most grateful for a description of the item so that
> I can purchase a set.
> Thanks in anticipation,
> Peter Mitchell
> Perth Australia
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the
> bottom and follow instructions:
> Back-up list and photos at:
Webmaster of The Rover Car Club of Canada
Webmaster of a variety of sites from:
Need a vacation? Get great deals
to amazing places on Yahoo! Travel.
More information about the rovernet