[ROVERNET - UK] Re: Carb manifold to head gasket
David Sheuring
rovertcv8 at yahoo.com
Wed Mar 28 02:03:46 BST 2007
Hi Tom,
You can go to any good parts store and get a roll or
sheet of gasket material and use the intake and cut it
out.
Then I would use either black or the new gray gasket
sealer on the manifold and the head and let is dry a
bit, then bolt it in. Works for me everytime.
Cheers
David
--- "T. Clemen" <tclemen at msn.com> wrote:
> My engine is 2000 TC
>
> Thanks
>
> Tom C.
>
>
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the
> bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> Back-up list and photos at:
> http://autos.groups.yahoo.com/group/Rover_net/
>
____________________________________________________________________________________
Looking for earth-friendly autos?
Browse Top Cars by "Green Rating" at Yahoo! Autos' Green Center.
http://autos.yahoo.com/green_center/
More information about the rovernet
mailing list