[ROVERNET - UK] And now, let's upset P6 lovers...
Eric Russell
p6rovers at yahoo.com
Thu Nov 29 04:57:29 GMT 2007
I'll loan you my angle grinder.
Where would you like the hole? :-)
Eric
--- Glen Wilson <rovercar at comcast.net> wrote:
> Aidrian Bridgeman-Sutton wrote:
> > Poorly designed is a bit strong - remember that
> the assumption when
> > the car was designed was that the brakes would be
> serviced by properly
> > trained mechanics who had the necessary tools and
> equipment to do the
> > job properly. If you have a hoist and all the
> proper tools and service
> > a few sets of calipers every year it's not too
> bad;
>
> Well, I think serviceability is a key factor in a
> good design. I'll bet
> Rover mechanics hated doing the rear brakes, even
> with proper training
> and the right tools. In the U.S. market, you sure
> couldn't trust the job
> to the gas station on the corner, and that didn't
> help the car's
> reputation and therefore sales.
>
> At least an access panel would have helped.
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the
> bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> Back-up list and photos at:
> http://autos.groups.yahoo.com/group/Rover_net/
>
Webmaster of The Rover Car Club of Canada
Website: http://www.roverclub.ca/
Webmaster of a variety of sites from:
http://www.websrus.ca
____________________________________________________________________________________
Be a better sports nut! Let your teams follow you
with Yahoo Mobile. Try it now. http://mobile.yahoo.com/sports;_ylt=At9_qDKvtAbMuh1G1SQtBI7ntAcJ
More information about the rovernet
mailing list