[ROVERNET - UK] Hand Brake Linkage

[Paul Smith]

The 2000 manual indicates the outer cable and inner cable ends are located
via screws and plates, so the linkage can be separated.
I can scan the page if desired.

PVS
----- Original Message ----- 
From: "Ray Wilkins" <rwilkins at connexus.net.au>
To: <rovernet at lyris.ccdata.com>
Sent: Sunday, September 12, 2004 9:49 AM
Subject: [ROVERNET - UK] Hand Brake Linkage


During the ongoing wrecking of my spare car I removed the entire
handbrake linkage and although greasy and a bit (surface) rusty, was in
good condition, especially the rubber grommets. However, on checking the
linkage in my 'good' car (because I felt that the handbrake was set too
tight) I found that the rearmost grommet (between the 2 arms of the
linkage adjacent to the rear calipers) was shot to pieces. Ah Ha, I said
to myself, I'll remove the good one from the spare and change them over!
The question now is "how?" They do not seem to come off and over the end
of the cable. Does anyone have any ideas? Or done this before? All help
would be appreciated.

Cheers,

Ray Wilkins
Melbourne, Australia
1976 P6B Almond





_______________________________________________
rovernet mailing list
rovernet at lyris.ccdata.com
To unsubscribe, go to this web page, look near the bottom and follow
instructions:
http://mailman.nipltd.com/mailman/listinfo/rovernet