[ROVERNET - UK] Introduction/Questions
Paul Smith
Paul.Smith at auroraenergy.com.au
Thu Sep 16 23:40:29 BST 2004
UGGH! Not Any plastic! Nylon so far as I know!
PVS
-----Original Message-----
From: Vern Klukas [mailto:vern at inkspotco.com]
Sent: Friday, 17 September 2004 6:09 am
To: rovernet at lyris.ccdata.com
Subject: Re: [ROVERNET - UK] Introduction/Questions
Frank said:
>Thanks Vern, and everyone else. I appreciate the info and am very
>glad to see that an active Rover community exists.
>
>On the generator, it appears that the slider bracket for adjusting
>the belt tension is, um, plastic? Is this right?
Yes, that is correct.
>
>The trunk hinges are shot because the PO pushed the car onto a tow
>dolly with another car and pushed the bumper into the boot, denting
>it and bending the hinges so that it will no longer close. He said
>the brakes were locked. Other than that the car was /is pretty
>straight and complete though a bit rusty in some spots. A bunch of
>spots.
I suspect that if you look closer, it is the truck lid that is bend.
But it cpould well be the hinges.
>
>The car was originally the pale yellow one, I don't know the name of it.
April Yellow
Yours
Vern
--
Vern Klukas I'm a little . . .
Inkspot Type & Design
vern at inkspotco.com
_______________________________________________
rovernet mailing list
rovernet at lyris.ccdata.com
To unsubscribe, go to this web page, look near the bottom and follow
instructions:
http://mailman.nipltd.com/mailman/listinfo/rovernet
More information about the rovernet
mailing list