[ROVERNET - UK] P6 girling callipers
Paul Smith
Paul.Smith at auroraenergy.com.au
Mon Aug 1 00:04:32 BST 2005
I just filed mine, it does not appear to be hardened.
Be ware of leaving any dags on it - I did and it wound up not slipping over
to the next tooth on the wheel, it just pushed and pulled the same tooth.
What you are proposing sounds like a speccy job.
PVS
-----Original Message-----
From: rogerdm at iprimus.com.au [mailto:rogerdm at iprimus.com.au]
Sent: Monday, 1 August 2005 8:47 am
To: rovernet at lyris.ccdata.com
Subject: [ROVERNET - UK] P6 girling callipers
Hi all
Has anyone undertaken a repair of the engagement face of the pawl that
clicks
into the teath on the push rod, thereby actuating the self ajustment. I
am doing up another set of callipers for another car and I have noticed that
on all my current spare bits, the face of the pawl is worn. This may limit
correct engagement and hence ajustment. Naturally I don't want to
recondition
and fit a set of callipers only to have them fail in this regard. I have
contemplated welding a small blob of metal onto the face and grinding it
to shape, and silver soldering on a piece of tool steel. However both
procedures
would be difficult given size, correct angles etc. Perhaps someone has
managed
to buy a new part, if so from where? All suggestions gratefully received
cheers Roger Matheson
_______________________________________________
rovernet mailing list
rovernet at lyris.ccdata.com
To unsubscribe, go to this web page, look near the bottom and follow
instructions:
http://mailman.nipltd.com/mailman/listinfo/rovernet
More information about the rovernet
mailing list