[ROVERNET - UK] Rover P6B rear brake hoses
giannid at bigpond.com
Fri Dec 1 09:45:29 GMT 2006
thanks for the quick reply Paul
when you say the "right spanner" what do you have in mind.
I am impressed that you can get to them at all, it looks very tight to me!
----- Original Message -----
From: "Paul Smith" <vmitps at netspace.net.au>
To: <rovernet at lyris.ccdata.com>
Sent: Friday, December 01, 2006 8:34 PM
Subject: Re: [ROVERNET - UK] Rover P6B rear brake hoses
> The one from R caliper to base unit is not too bad.
> The joiner one is harder, but can be done with diff up. You need the
> spanner though.
> There are 2 bolts at the rear of the diff, plus the panhard rod bolt. The
> downside of releasing them is the the jack to support the diff would be in
> the way.
> ----- Original Message -----
> From: "Gianni D'Ortenzio" <giannid at bigpond.com>
> To: <rovernet at lyris.ccdata.com>
> Sent: Friday, December 01, 2006 8:24 PM
> Subject: Re: [ROVERNET - UK] Rover P6B rear brake hoses
>> I have to replace the rear brake hoses to make my car roadworthy and have
>> had different opinions on how best to do it.
>> I have been told to take the calipers off to do the job.
>> Alternatively I have been told that I can release the four bolts at the
>> of the diff and it will go down a few inches, enought to acess and change
>> the two hoses.
>> The manula is strangely silnet on this
>> Anyone done it recently and have some advice?
>> rovernet mailing list
>> rovernet at lyris.ccdata.com
>> To unsubscribe, go to this web page, look near the bottom and follow
>> Back-up list and photos at:
>> No virus found in this incoming message.
>> Checked by AVG Free Edition.
>> Version: 7.5.430 / Virus Database: 268.15.2/560 - Release Date:
> 3:41 PM
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow
> Back-up list and photos at:
More information about the rovernet