[ROVERNET - UK] P5 jockey pulley (was interesting pair)

Kent Kinard kkinard at swbell.net
Fri Jan 13 21:53:07 GMT 2006

That would be great.  Thanks.  Let me know what the total cost will be.

Rev. Kent Kinard
P.O.Box 14
502 Robert Lee Highway
Sterling City, TX 76951

Kent K.

Ben Rodgers wrote:

> Hi Kent
>            I went out to the barn this morning, what a morning! the sun is
> shining, it is warm, and the snow has disappeared.
> Anyway to business! I wanted to double check with you first that I have the
> parts you need, I have removed the adjusting bracket from a P4 -100 engine,
> also the generator pulley. The dimensions are as follows Pulley - 3 1/2 inch
> dia, 1/2 inch width/grove. Bracket is 4 1/2 inch length with a bend angle to
> fit dynamo recess bracket. If these or what you need let me have a mailing
> address and I'll get them off to you.
>                                                             Regards  Ben
> born in Belfast, Northern Ireland,
> Author of "lily and me" a great book and a great read .
> Order on line at amazon.com. Book # ISBN1-55430-019-3
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> Back-up list and photos at:
> http://autos.groups.yahoo.com/group/Rover_net/

More information about the rovernet mailing list