[ROVERNET - UK] more servo woes
Eric Russell
p6rovers at yahoo.com
Mon Oct 23 02:00:47 BST 2006
My Rover brakes stuck on due to the servo air valve
being stuck by a rust film.
I popped the valve out, examined it, rectified the
problem, reinserted it, and solved the problem.
Eric
--- peter king <peter at king-co.com> wrote:
> A frustrating day on the Rover farm today. I rebuilt
> the P5 servo
> yesterday, and installed it today, but the brakes
> stuck on after
> starting the car. I removed the servo and re-aligned
> the piston,
> afraid that it was binding. After a second
> installation, the brakes
> still stick.
>
> The vacuum line valve is operating properly
> (one-way), no fluid
> leaking past the seals into the vacuum chamber, so
> at least that
> problem is fixed, but what other problem should I
> look for? There
> were two small "O" rings in the rebuild kit which I
> could not find
> any use for. Might I have left something out?
>
> Any thoughts would be greatly appreciated.
>
> Thanks,
>
> Peter
>
>
>
> _______________________________________________
> rovernet mailing list
> rovernet at lyris.ccdata.com
> To unsubscribe, go to this web page, look near the
> bottom and follow instructions:
> http://mailman.nipltd.com/mailman/listinfo/rovernet
> Back-up list and photos at:
> http://autos.groups.yahoo.com/group/Rover_net/
>
Webmaster:
The Rover Car Club of Canada - www.roverclub.ca
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
More information about the rovernet
mailing list