[ROVERNET - UK] Clutch master cylinder

[Creig Houghtaling]

Steven,
The method an old mechanic taught me to bleed a clutch system is very
similar to Eric Russell's method.  That is to disconnect the slave, let it
hang down so the bleed screw is at the highest point.  Attach a long clear
rubber tube to the bleed screw and put the open end back to the master
reservoir.  Then pump till there is no more air coming up the tube.
With this method you can pump as much as needed to remove all the air from
both the master and slave and with the clear tube coming back up to the
reservoir you can easily see when the air is gone.
Creig Houghtaling
St. Louis, MO

-----Original Message-----
From: rovernet-bounces at lyris.ccdata.com
[mailto:rovernet-bounces at lyris.ccdata.com]On Behalf Of Steven Dibdin
Sent: Monday, September 18, 2006 7:34 AM
To: rovernet at lyris.ccdata.com
Subject: [ROVERNET - UK] Clutch master cylinder

--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.405 / Virus Database: 268.12.5/450 - Release Date: 9/18/2006