[ROVERNET - UK] P6 2000 TC servo boost
Steven Dibdin
sdibdin at hotmail.com
Sun Dec 2 15:25:42 GMT 2007
Hi Peter, It is Peter right?
I gathered that, but I believe that the servo was given a figure as a benchmark for listings. 3500s had 4.25:1 for instance, I think that referred to the a theoretical full vacuum applied against the diaphram applied through the servo piston in relation to the hydraulic pressure from the master cylinder. Would that make sense?
Would you happen to know Girling's part number for the 7" servo used on TC's?
Thanks,
Steven
More information about the rovernet
mailing list