[ROVERNET - UK] P6 2000 TC servo boost

[Vern Klukas]

I did a little research on this, it appears thw size of the vacuum 
piston is irrelevant, it is the ratio between the area of the control 
piston (the little one that operates the airvalve) and the slave 
cylinder (the main hydraulic bore of the servo) that counts.

Based on that, the ratio should be 2.78:1, which is the same number 
as the Girling MkII servo used on the P4 110  ( 
www.head2head.free-online.co.uk/Rover/servo.htm )

Perhaps more later, I'm going to poke around a bit more.

Yours
Vern
-- 
Vern Klukas                             I'm a little . . .
Inkspot Type & Design
vern at inkspotco.com