R: [ROVERNET - UK] Rear window Seals

Paul Smith Paul.Smith at auroraenergy.com.au
Tue Jul 3 00:08:39 BST 2007

It sounds like he did not jack the screen up properly - like Everything on a P6 it is adjustable, there are little screw jacks on the base of the screen.
Wind those up until the gap is gone.
However it should have new sealant applied...


-----Original Message-----
From: rovernet-bounces at lyris.ccdata.com
[mailto:rovernet-bounces at lyris.ccdata.com]On Behalf Of Ruotolo Gianluca
Sent: Tuesday, 3 July 2007 3:42 am
To: rovernet at lyris.ccdata.com
Subject: R: R: [ROVERNET - UK] Rear window Seals

Dear friends,

		 I need an advice.

The coachbuildfer gave me my p6, everything is ok and the car is

As usual, in this dream there is something wrong.

The glasses were removed and the rear window was not fitted in its
position properly.

The seal does not touch the roof and there is a cleft of more or less
0,5 mm, so water comes in.

The mechanic does not want to do this job again, so is there a bigger
seal or do I have to remove the window and to fit it properly?
In my opinion with the roof in its place everything should be easier.

Your advices wuill be appreciated.

Best regards, thanks in advance, Gianluca.

rovernet mailing list
rovernet at lyris.ccdata.com
To unsubscribe, go to this web page, look near the bottom and follow instructions:
Back-up list and photos at:

More information about the rovernet mailing list