[ROVERNET - UK] OT - uns*bscribe
ikke nie
rover1000 at hotmail.com
Mon May 15 08:00:41 BST 2006
This is definately a "OT".... not a rover in sight there
>From: David Read <defender110 at ozemail.com.au>
>Reply-To: rovernet at lyris.ccdata.com
>To: rovernet at lyris.ccdata.com
>Subject: Re: [ROVERNET - UK] uns*bscribe
>Date: Mon, 15 May 2006 14:52:29 +0930
>
>Andrew !!!!!
>You forgot to mention that re-subcribing is the reverse of the above.
>
>:-)
>
>Dave
>South Oz
>
>Andrew H. Litkowiak wrote:
>>Peter Mitchell wrote:
>>>Hi Eric,
>>>
>>>I am going off the net for a week or two for pc repair / upgrade, please
>>>unsubscribe me for the present.
>>>
>>>Kind regards
>>
>>Here is how to unsubscribe:
>>
>>First, e-mail rovernet-request and ask for an Unsubscribing Kit. Then
>>follow these simple directions.
>>
>>The kit is the standard no-fault type. Depending on requirements, System A
>>and/or System B can be used. When operating System A, depress lever and a
>>plastic dalkron unsubscriber will be dispensed through the slot
>>immediately underneath. When you have fastened the adhesive lip, attach
>>connection marked by the large "X" outlet hose. Twist the silver- colored
>>ring one inch below the connection point until you feel it lock.
>>
>>The kit is now ready for use. The unsubscriber is activated by the small
>>switch on the lip. When securing, twist the ring back to its initial
>>condition, so that the two orange lines meet. Disconnect. Place the
>>dalkron unsubscriber in the vacuum receptacle to the rear. Activate by
>>pressing the blue button.
>>
>>The controls for System B are located on the opposite side. The red
>>release switch places the unsubscriber into position; it can be adjusted
>>manually up or down by pressing the blue manual release button. The
>>opening is self-adjusting. To secure after use, press the green button,
>>which simultaneously activates the evaporator and returns the unsubscriber
>>to its storage position.
>>
>>You may log off if the green exit light is on over the evaporator. If the
>>red light is illuminated, one of the unsubscriber requirements has not
>>been properly implemented. Press the "List Admin" call button on the right
>>of the evaporator. I will secure all facilities from my control panel.
>>
>>To use the Auto-Unsub, first undress and place all your clothes in the
>>clothes rack. Put on the Velcro slippers located in the cabinet
>>immediately below. Enter the Con-tainer, taking the entire kit with you.
>>On the control panel to your upper right upon entering you will see a
>>"Con-tainer seal" button. Press to activate. A green light will then be
>>illuminated immediately below. On the intensity knob, select the desired
>>setting. Now depress the Auto-Unsub activation lever. Act normally.
>>
>>The Auto-Unsub will automatically go off after three minutes unless you
>>activate the "Manual off" override switch by flipping it up. When you are
>>ready to leave, press the blue "Con-tainer seal" release button. The door
>>will open and you may leave. Please remove the Velcro slippers and place
>>them in their receptacle.
>>
>>If you prefer the ultrasonic log-off mode, press the indicated blue
>>button. When the twin panels open, pull forward by rings A & B. The knob
>>to the left, just below the blue light, has three settings, low, medium or
>>high. For normal use, the medium setting is suggested. After these
>>settings have been made, you can activate the device by switching to the
>>"ON" position the clearly marked red switch. If during the Unsubscribing
>>operation, you wish to change the settings, place the "manual off"
>>override switch in the "OFF" position. You may now make the change and
>>repeat the cycle. When the green exit light goes on, you may log off and
>>have lunch. Please close the door behind you. Don't forget to dressb efore
>>leaving the room.
>
><snip>
>
>_______________________________________________
>rovernet mailing list
>rovernet at lyris.ccdata.com
>To unsubscribe, go to this web page, look near the bottom and follow
>instructions:
>http://mailman.nipltd.com/mailman/listinfo/rovernet
>Back-up list and photos at:
>http://autos.groups.yahoo.com/group/Rover_net/
More information about the rovernet
mailing list